When did I install my Webasto gas heater?

When did I install my Webasto gas heater?

This post was originally written in early 2020, it documented my Webasto installation process from the summer of 2019. Since then, I have been schooled in the wild world of Webasto and updated this post significantly in January of 2021.

Why is the back of the lid on a MGB Roadster?

Because there is just a simple hinge at the back of the lid it allows a lot of sideways movement of the front of the lid, but the peg and clip were fitted such that this sideways movement puts the greatest stress on the plastic peg in its weakest direction.

Where to file body fittings on MGB Roadster?

Only file the minimum width needed for the clip, and in the middle of the sides of the hole, which will stop the clip sliding fore and aft and revealing the edges of the old hole (as well as nullifying the point of the exercise by putting the peg out of alignment with the clip again).

What does Webasto thermo do for a boat?

Webasto offers cutting-edge solutions to improve aftertreatment performance, reduce idle-time, reduce fuel consumption and reduce engine maintenance by pre-conditioning the engine prior to starting the main power unit. Nothing ruins a day of fun on the water than a boat that is not working properly.

What does the fault code mean on a Webasto heater?

On many models of Webasto heaters the green operating status light offers you an fault indication should the heater experience any difficulty during operation. If you have a Webasto timer installed, the fault indication may even be shown in the form of a code (F03 for example).

What should I do if my Webasto heater overheats?

Bleeding the system thoroughly and fixing any leaks is the best starting point, and can be time-consuming. Overheating can also occur when there are no blockages in the coolant system, and you may have to go to the extent of draining and flushing the system to clear any restrictions.

Where is the temperature sensor on a Webasto 90?

The temperature sensor on a Thermo 90 unit is located in the water pipe outlet of the heater. This fault suggests that there is an open or short circuit of the sensor, or that it is corroded and needs replacing.

Why does my Winnebago roof keep blowing off?

Winnebago owners are experiencing a weak point with these fiberglass roofs. The nice, rigid fiberglass roofs are blowing off while going down the road or during storms with extreme wind. The first reaction is to say the owner hasn’t been taking care of the roof, hasn’t been maintaining the caulking.