Where should shower rod be placed?

For best fit, shower curtain should be 6″ – 12″ wider than shower rod. Mount rod approximately 3″ inside the point a straight rod is normally mounted. The midpoint of the rod should extend several inches past the outside rim of the tub. Depending upon tub model, mount rod between 6″ and 8″ from center line of the tub.

How far down should a shower curtain hang?

around 75 to 77 inches
The curtain rod should be installed around 75 to 77 inches from the floor, since a standard shower curtain is 72 inches long.

What is standard shower rod length?

72 x 72 inches
What is standard shower curtain size? The standard shower curtain size is 72 x 72 inches. Standard shower curtain length extends to the floor and covers the tub. Of course, if you have a custom shower, standard curtain panel sizes may not be the right fit for your shower.

How far does a curved shower rod stick out?

A curved shower rod should be mounted 3 inches closer to the shower wall than the standard rod would be mounted. You can’t tuck the ends of the liner into the tub if you don’t compensate for the rod’s curve.

How do I keep my shower rod from falling down?

First, adjust your shower curtain to be a few inches longer than the shower. Hang the shower curtain rod at an angle, with one end several inches higher than you want it. Slowly slide that end down until the rod is hanging straight. The felt pads keep it from sliding further down the tile wall.

Why does my shower rod keep falling down?

Tension rods can fall if the walls of your shower are dry. Drywall causes the rods to become loose and end up falling due to a lack of strong support. In order to avoid this issue, ensure the rods have extra support such as by using glue shelf rubber lining on the walls as we have discussed below.

How tall should shower rods be on Wall?

Mark the location for the wall’s hardware using the center point and shower curtain’s length as a guide to gauge the mark’s height. Allow for about 6 inches of material to fall below the top of the tub.

Where does the shower curtain rod go on the wall?

The shower curtain rod does not mount to these walls in most cases. It mounts to the bathroom wall, about 1 inch above this sidewall. The mounting brackets screw into place in the bathroom wall’s drywall.

Where to place a shower rod in a tub?

If you drill into the tub sidewalls, which are made of fiberglass, you ruin the watertight nature of the tub walls. If your shower rod is spring loaded with plastic nubs on the end, mount it anywhere you like. It installs on tub sidewalls or bathroom walls. Once you find the proper height, level the shower rod.

What happens when you have a curved shower rod?

When you have soap in your eyes and you need to turn around in the shower, you sometimes reach for the shower curtain to find your way to the water nozzle or a towel. When you have a curved shower curtain rod, the curtain is pushed away from you and unavailable to use as a guide.

Where do you mount a curved shower rod?

Depending upon tub model, mount rod between 6″ and 8″ from center line of the tub. The middle portion of the rod should curve just outside the contour of the tub. Review the Curved Shower Rod Mounting Instructions above to determine proper rod placement. Assemble curved shower rod. Hand-tighten remaining screws. Do not use set screws at this time.

What are the dimensions of shower curtain rods?

The dimensions of shaped rods, however, may be fixed. Mounted shower curtain rods will support curtain weight up to about 25 to 30 pounds. Tension shower curtain rods are by far the easiest to install.

What happens if you get caught in a shower rod?

Getting caught in the shower curtain while turning or moving in the shower can cause property damage and result in injury. You can tear your shower curtain away from its rings and damage the tub where the shower curtain rod is installed. Someone who gets wrapped up in the shower curtain can fall and hurt himself.

Where should shower rod be placed?